| 塑料袋制袋机最基本的操作流程 |
| 添加时间：2017/6/12 15:44:26 浏览次数： |
| 塑料袋制袋机最基本的操作流程 The basic operating procedure of plastic bag making machine （1）开机前的准备工作 ： (1) preparation before turning on: ①检查设备周围是否有灰尘、杂物，并将其清除。 Check for dust and debris around the equipment and remove it. ②按生产通知单的要求上好膜卷。 The film is required by the production order. ③按生产通知单和工艺文件调整好袋的尺寸，安装好热封刀，并初步调好 Adjust the size of the bag according to the production order and the process document, install the hot sealing knife, and make a preliminary adjustment ④分切刀和热封刀的位置。 The position of the cutter and the heat sealing knife. ⑤打开电源，按工艺文件要求设定热封刀温度。 Turn on the power supply and set the heat seal temperature according to the process document. ⑥输入制袋的相关数据以及每扎的所需个数。 The data in the input system and the number of requirements for each. ⑦选择色差较大的图案边沿左右调节光眼灵敏度，使其达到要求。 The choice of the color difference between the pattern and the left and right sides of the design is to adjust the sensitivity of the light eye to meet the requirement. （2）开机 (2) boot ①启动主电机，低速运转，随即调整边位控制，将膜对分在中间位置。 Start the main motor, operate at low speed, adjust the side position control, and divide the membrane into the middle position. ②调整左、右夹辊，使左右膜对齐，调整前后夹辊，使图案对正。 Adjust the left and right clamping roller to align the left and right membrane and adjust the back and back rolls to make the pattern correct. |③调整热封刀，使其热封在袋的要求范围。 | adjusts the heat seal to make it hot in the bag. ④调整分切刀片至所需位置，并把打孔位置调整到剪刀口。 Adjust the cutting blade to the desired position and adjust the punching position to the scissors. ⑤初步调整好机速，取一次平出的样袋，进行初检。 First adjust the speed of the machine, take a flat sample bag and conduct the initial inspection. ⑥生产过程中，随时观察制袋情况发现异常，即时调整。 In the process of production, it is always observed that the bag condition is abnormal and adjusted in real time. （3） 停机 断开总电源开关，再断开各部位电源开关。 (3) stop turning off the total power switch and turn off the power switch. |
| 上一页 制袋机常见故障 |
| 下一页 制袋机开机前的准备 |
Copyright © 技术支持：遨游网络