| 为什么气泡膜机螺杆要涂上防锈油？ |
| 添加时间：2019/10/28 16:06:57 浏览次数： |
| 气泡膜机生产的气泡膜是采用优质聚乙烯树脂加工而成，用于包装和填充的一种防压防潮防震的化工产品，广泛应用于物流行业。 The bubble film produced by bubble film machine is made of high-quality polyethylene resin. It is a kind of chemical product which is used for packing and filling, and is widely used in logistics industry. 气泡膜机应作定期的检修，每三个月对气垫膜机作一次彻底清洗，对各种轴承每三个月更换一次润滑脂，每半年对减速器更换一次润滑油，每二年对设备整体进行一次大修。检查气泡膜机的温度自控是否完好，加热器件是不否完好，各点温度是否在指标范围内来保证机器的正常运行。气泡膜机在料斗投料时，必须保证干净，严防金属杂物、砂石和小工具等进入料口，以防损伤机筒和螺杆，在运转中如发现有异常响声，应立即停车进行处理。 The air bubble film machine shall be overhauled regularly. The air bubble film machine shall be thoroughly cleaned every three months. All kinds of bearings shall be replaced with lubricating grease every three months. The reducer shall be replaced with lubricating oil every six months. The whole equipment shall be overhauled every two years. Check whether the temperature automatic control of the bubble film machine is in good condition, whether the heating device is in good condition, and whether the temperature of each point is within the index range to ensure the normal operation of the machine. When the bubble film machine is feeding in the hopper, it must be kept clean, and strictly prevent the metal sundries, sand and small tools from entering the material mouth, so as to prevent damage to the barrel and screw. If there is any abnormal noise in the operation, it shall be stopped immediately for treatment. 气泡膜机螺杆因故从机筒里取出，应妥善处理，以防变形，如果长时间内不装回机筒内，必须把螺杆垂直吊挂起来，防止碰伤、压弯和永久变形，机筒和螺杆表面均涂上防锈油作保护。 The screw of bubble film machine is taken out from the barrel for some reasons, and it shall be properly treated to prevent deformation. If it is not installed back into the barrel for a long time, the screw must be hung vertically to prevent bumping, bending and permanent deformation. The surface of the barrel and the screw shall be coated with antirust oil for protection. |
| 上一页 什么是无尘布制袋机？ |
| 下一页 为什么快递用气泡膜包装 |
Copyright © 技术支持：遨游网络