一、制袋机常见问题解决于：
First, the common problems of bag making machine are solved:
1、 平口机的冷切刀切不断是什么原因？
1. What is the reason for the cold cutting knife cutting of the flat mouth machine?
① 刀不利，需要重新磨好。
The knife is bad and needs to be re grinded.
② 刀滑块使用久磨损有间隙，导致刀不平衡。需要调好上下刀的平衡度。
Second, the tool slider has long wear and tear, which leads to the unbalance of the knife. It is necessary to adjust the balance of the upper and lower knives.
2、平口机如果切三条或多条，会出现袋子尺寸长短是什么原因？
2, if the flat mouth machine cuts three or more strips, what is the reason for the size of the bag?
①在那一条薄的膜后胶辊上垫上一层。这样就可以与其它的料均衡。
(1) a thin film on the top of the rubber roller. This can be balanced with other materials.
3、平口机的弹簧会断是什么原因？
3. What is the reason why the spring of the flat mouth machine will be broken?
自粘条没有贴到位翘起来卷进弹簧，那么弹簧就会断，在操作上自粘条一定要粘好。第二种原因是料不整齐或一坨塞进胶辊，导致弹簧不顺断掉。
The self-adhesive strips are not put in place to roll up the spring, then the spring will break, and the self-adhesive strips must be sticky on the operation. The second reason is that the material is not neat or a lump is stuffed into the rubber roller, which causes the spring not to break down.
4、骨袋制袋机封边一边封得漂亮一边不够漂亮是什么原因？
4. What's the reason for the beautiful side of the bag bag machine and the beautiful side is not beautiful enough?
需将铝压辊调试好到封边两边都压得到，不然就会产生以上情况。
The aluminum pressure roller must be adjusted to both sides of the edge, otherwise the above situation will be produced.
5、边封机切自粘条经常粘到输送带是什么原因？
5. What is the reason why the side sealing machine is often stuck to the conveyor belt?
自粘条错位，粘到了输送带，需要将后面的纠边机的自粘位调试好，把纠边电眼一定要放在自粘位纠边。防止跑位。
Self-adhesive strip dislocation, and sticks to the conveyor belt, to the back of the edge correction machine a self-adhesive debugging, the edge correction must be placed in a self-adhesive electric eye edge correction. Prevent movement.